Avaya 1000 Installation And Commissioning Manual page 184

Emergency Services configuration
3. Configure ESN.
ESA uses a route number rather than ESN route list index. However, ESN is required at the
Branch Office.
4. Configure Emergency Services Access (ESA) in LD 24.
Configure an ACD number as an Emergency Services Directory Number.
Table 28: LD 24 — Configure Emergency Services Access
Prompt
REQ
TYPE
CUST
ESDN
ESRT
DDGT
DFCL
OSDN
5. Configure the Branch Office zone on the main office.
a. Configure the Branch Office zone's ESA dialing information in LD 117.
Table 29: LD 117 — Configure Branch Office zone ESA route
Command
CHG ZESA <Zone><ESA Route #><AC><ESA Prefix><ESA Locator>
Branch Office Installation and Commissioning
184
Response Description
NEW Add new data, or change existing data.
CHG
ESA Emergency Services Access data block
xx Customer number as defined in LD 15
xxxx Emergency Services DN (for example, 911). Up to four digits
are accepted.
ESA route number
0-511 Range for CSLS and Avaya CS 1000E system
0-127 Range for Media Gateway 1000B
x...x Directing Digits (for example, 1, 11, or 911). Up to four digits are
accepted.
x...x Default ESA Calling Number. The input must be the following
lengths:
• On a system that is not FNP equipped, 8 or 11 digits are
accepted if the first digit of the input is "1"; otherwise the input
must be 7 or 10 digits.
• On a system that is FNP equipped, up to 16 digits are allowed.
x...x On-Site Notification station DN. The input must be a valid single
appearance internal DN.
Description
Defines the ESA parameters for the Branch Office zone, where:
• Zone = Zone number for the Branch Office.
• ESA Route # = Virtual Trunk route to MG 1000B Core.
• AC = Access Code to add to dialed digits. If no AC is required,
AC0 is to be entered in place of AC1 or AC2.
• ESA Prefix = Digit string added to start of ESDN. This is a
unique prefix in the NRS. Avaya recommends that users use
Comments? infodev@avaya.com
June 2014