Avaya 1000 Installation And Commissioning Manual page 144

MG 1000B software installation
Configuring primary and secondary call server IP addresses
Given: Primary IP address: 47.1.1.10 ; Secondary IP address: Subnet mask: 255.255.255.0; Default
Gateway IP: 47.1.1.1
1. Go into LD117.
2. Create host entries. Enter one of the following commands:
NEW HOST PRIMARY_IP 47.1.1.10
NEW HOST GATEWAY_IP 47.1.1.1 (if connected to customer LAN)
NEW HOST GATEWAY_IP 47.1.1.1
3. Assign host to primary and/or secondary IP address(es). Enter one of the following
commands:
CHG ELNK ACTIVE PRIMARY_IP
CHG ELNK INACTIVE SECONDARY_IP (for Dual CPU only)
Verify your IP address for Ethernet by entering the PRT ENLK command.
Note:
To reuse the active host entry and/or associated IP address, the existing entry must be
removed. Prior to removing the existing enty, you must first create a temporary host
entry and make it active. Out the original host entry, then proceed to Step 2.
4. Set up Ethernet subnet mask. Enter the command:
CHG MASK 255.255.255.0
Verify subnet mask setting by entering the command:
PRT MASK
5. Set up routing entry. Enter the command:
NEW ROUTE <destination IP> 47.1.1.1: (if connected to customer LAN)
Where: <destination IP> = destination network IP and <gateway IP> = default gateway IP
Note:
When more than one gateway exists, replace 0.0.0.0 with the destination network
address for each entry of the routing table.
6. Verify default routing by entering the command:
PRT ROUTE
Note:
For a single CPU machine, the secondary IP is not used.
Note:
The secondary IP is accessible only when a system is in split mode.
Branch Office Installation and Commissioning
144
Comments? infodev@avaya.com
June 2014