Avaya 1000 Installation And Commissioning Manual page 95

i. Configure the Branch Office (Customer Data Block and ELAN subnet).
j. Configure the Branch Office dialing plan.
k. Configure the Voice Gateway Media Cards. Refer to Avaya Signaling Server IP Line
Applications Fundamentals, NN43001-125.
Use the same zone for DSP physical TNs and IP Phone TNs. The zone number must
match that at the main office. Refer to Avaya Signaling Server IP Line Applications
Fundamentals, NN43001-125.
l. Install and provision the local trunks (the XUT, PRI, and DTI cards). Refer to Avaya
Communication Server 1000M and Meridian 1 Small System Installation and
Commissioning , NN43011-310.
m. If applicable, configure Abbreviated Dialing.
n. Provision the Virtual Trunks. Refer to Avaya IP Peer Networking Installation and
Commissioning, NN43001-313.
When configuring NRS, enable the Network Connection Service (NCS). Ensure that
each Branch User ID (BUID) is entered in the Branch Office numbering plan so it points
to the Main Office. This ensures that the Branch User will be properly redirected to the
main office. Ensure the Signaling Server H.323 ID matches the gateway endpoint name
on NRS (in SIP environment as well). Refer to
the NRS database
o. Configure the IP Phones as Branch Users. Refer to
page 164 for details on Branch User Configuation.
June 2014
on page 160 for more information.
Comments? infodev@avaya.com
Adding the Branch Office endpoints to
Branch User Config command
Branch Office Installation and Commissioning
Implementation summary
on
95