Avaya 1000 Installation And Commissioning Manual page 167

5. To enter the Main Office TN:
• Choose Select to accept the default Main Office TN on the display.
• Enter the Main Office TN in l s c u, and press Select.
The default value is the Branch Office TN in l s c u. See
Number on page 167, which shows an example of the display of a TN in Small System
format.
Figure 69: Main Office Terminal Number
6. Enter the IP Phone Installer's Password, Temporary Internet Installer's Password for the
main office, or the SCPW for the Main Office TN. See
page 167.
Figure 70: Main office password
Following entry of this data, the IP Phone is taken offline and the display shows "Locating
Remote Server". The IP Phone registers with the main office and becomes operational.
Caution:
Network Problems During Installation:
Setup:The IP Phone in the Branch Office is on a different subnet to the MG 1000B TPS
and has a different route to the main office. The MG 1000B TPS can connect to the main
office but the IP Phone cannot.
Symptom: The terminal registers to the MG 1000B TPS and is redirected to the main
office (displaying the "Locating Remote Server" message). When it does not successfully
June 2014 Branch Office Installation and Commissioning
Comments? infodev@avaya.com
Branch User Config command
Figure 69: Main Office Terminal
Figure 70: Main office password on
167