Avaya 1000 Installation And Commissioning Manual page 185

Command
b. Enable the Branch Office zone ESA in LD 117
ENL ZBR <Zone> ESA
6. Configure the ESA Special Number at the main office.
a. Configure the ESA Special Number in the NRS. Using NRS, configure the ESA Special
Number defined for the Branch Office zone. Refer to Avaya IP Peer Networking
Installation and Commissioning , NN43001-313.
Avaya recommends that customers use "0" + the ESN Location code + ESDN. An
example for location code 725 would be 0725911. The zero is recommended to prevent
a collision in the ESN data with the HLOC entry.
b. Configure the ESN Special Number at the main office.
a. Configure the Digit Manipulation Index in LD 86 with the DGT feature.
Table 30: LD 86 — Configure Digit Manipulation Index
Prompt
REQ
CUST
FEAT
DMI
DEL
INST
CTYP
b. Configure the Route List Index in LD 86 with the RLB feature.
June 2014
Description
"0" + ESN location code of the Branch Office node. An example
for location code 725 would be: 0725.
• ESA Locator = Direct Inward Dial telephone number to be sent
as part of ANI for use by the PSAP to locate the source of the
call.
Response Description
NEW Add new data.
xx Customer number as defined in LD 15
DGT Digit manipulation data block
Digit Manipulation Index numbers
(0) No digit manipulation required
(0)-31 CDP
(0)-255 NARS and BARS
(0)-1999 NARS and BARS with FNP
DMI is only prompted when the Directory Number
Expansion (DNXP) package 150 is equipped and
SDRR = LDID.
The maximum number of Digit Manipulation tables is
defined by prompt MXDM. DMI is not prompted if route
TKTP = ADM.
(0)-19 Number of leading digits to be deleted
x...x Insert. Up to 31 leading digits can be inserted.
<cr> Call type to be used by the manipulated digits. This
call type must be recognized by the far-end switch.
Branch Office Installation and Commissioning
Comments? infodev@avaya.com
Emergency Services Access (ESA)
185