NEC Univerge NEAX 2000 IPS Command Manual page 52

CONDITION
Commands which require a
reset of the BRT card after
data setting.
• Set the Make Busy switch
to UP and then DOWN.
BRT INITIAL
Commands which require a
reset of the CIR card after
data setting.
• Set the Make Busy switch
to UP and then DOWN.
CIR INITIAL
Commands which require a
reset of the CSH card after
data setting.
• Set the Make Busy switch
to UP and then DOWN.
CSH INITIAL
Commands which can be
used only under Off-Line
mode of the MP card. See
"METHOD OF SETTING
ON-LINE/OFF-LINE
MODE". Page 31
OFF LINE
NOTE: Before the MP card is placed into Off-Line mode, the system data backup must be executed by
CMEC Y=6>0:0.
Conditions for Using Commands
COMMANDS
CM08>644
CM35 Y=79
CM35 Y=144
CM35 Y=283
CMAA Y=06
CM08>489
CMAD Y=24
CMAE Y=00>03, 04, 05,
Y=10, Y=11, Y=15, Y=19,
Y=42
CM00
CM01
CM0B Y=00>90
CMEC Y=4: CCC
CMEC Y=7>00
NOTE
CM4A Y=90
CONDITIONS FOR USING COMMANDS
Basic Service Features
Trunk Route Data
ISDN-BRI Layer 1 activation
TEI (Terminal Endpoint Identifier) assign-
ment for ISDN terminals
BRT Functions
Basic Service Features
Kind of CS/ZT
CS/ZT Operation Data Assignment
System Data Memory All Clear
System Data Memory Partial Clear
Remote Site Number Assignment
Maintenance by MAT/CAT
Day/Night Mode Change by System Clock
– 28 –
CHAPTER 2 PRECAUTION
MEANINGS
Continued on next page
NWA-008844-001 Rev.5.0
NOVEMBER/15/2006
91ch2001.fm