NEC Univerge NEAX 2000 IPS Command Manual page 245

COMMAND CODE TITLE:
12
Y
No. MEANING
33 Sending BLF message via
CCIS to Destination No.3
34 Sending BLF message via
CCIS to Destination No.4
35 Sending BLF message via
CCIS to Destination No.5
36 Sending BLF message via
CCIS to Destination No.6
37 Sending BLF message via
CCIS to Destination No.7
38 Number of Memory Block
for CID Call Back
NOTE 1:
The memory block cannot be used in common by multiple stations.
Set the memory block to each D
NOTE 2:
This command is not effective for a Single Line station/Virtual Line station/PS.
NOTE 3: The start block number set by the second data is as follows.
0000-1016
0000-4086
39 Location number of
term
D IP for Local Connec-
tion
[Series 3100]
43 Group number for Group
Call by Pilot Number Dial-
ing
NOTE: Effective only
when CM13 Y=45
is 0.
STATION CLASS-1
DATA
0 To send
1 Not sent
0 To send
1 Not sent
0 To send
1 Not sent
0 To send
1 Not sent
0 To send
1 Not sent
XXXXZZ XXXX: Start Block Number (0000-4086)
ZZ
NONE 4 blocks
term
[Series 3800 software or before]
[Series 3900 software or later]
00 Location number 00
63 Location number 63
NONE Location number 00
00 Group Call No. 00
19 Group Call No. 19
NONE Not assigned
SETTING DATA
MEANING
: Number of Memory Block for CID Call
Back
01: 8 blocks
02: 16 blocks
03: 24 blocks
station respectively.
– 221 –
CM12
: Initial Data
RELATED
COMMAND
CM50 Y=08>3
CM50 Y=08>4
CM50 Y=08>5
CM50 Y=08>6
CM50 Y=08>7
CM35 Y=150
CM67
CM13 Y=45
CM57 Y=10-
29
Continued on next page
NWA-008844-001 Rev.5.0
91ch3002.fm
JUNE/01/2007