NEC Univerge NEAX 2000 IPS Command Manual page 849

COMMAND CODE TITLE:
D001
1ST DATA: 229-256
DATA
229 Maximum accumulation rate of billing memory for external alarm
output when the rate exceeds assigned value
NOTE 1: The condition for external alarm is as follows;
(a) The accumulation rate for the following limit value
(b) The accumulation rate for the following limit value
(c) The accumulation rate for the following limit value
[Limit Value]
- Limit value of remaining Call Record memory set by
CMD003>24/29
NOTE 2: ON/OFF control for external relay on DK00 card and
fault information display can be performed with the con-
dition for external alarm as above.
For case (a): External relay ON/OFF set by
For case (b): External relay ON/fault information display
For case (c): External relay OFF/fault information dis-
SMDR/CIS/PMS FUNCTIONS (2)
1ST DATA
FUNCTION
approaches the value set by CMD001>229 in ad-
vance.
approaches full.
decreases than the assignable range set by
CMD001>229 or is cleared the stored billing memo-
ry.
CMD000>126
Fault information display set by CMEA
Y=2>28
set by CMEA Y=2>28
play set by CMEA Y=2>38
0
50-99: 50%-99%
– 825 –
CMD001
: Initial Data
2ND DATA
: 80%
Continued on next page
NWA-008844-001 Rev.5.0
JULY/01/2006
91ch3009.fm