NEC Univerge NEAX 2000 IPS Command Manual page 143

COMMAND CODE TITLE:
08
BASIC SERVICE FEATURE
457 Whether the fault information is cleared when the fault infor-
mation clear command is received from the RMAT
460 Send OAI SMFN STS (status) for Call Transfer from station
461 Send OAI SMFN when answering held call
462 Send ANI/Caller ID/CPN to OAI terminal
463 Send ANI/Caller ID/CPN to SMDR terminal
464 OAI TSAPI
SCF facility
465 SCF error code type
467 Method of readout the traffic information
[Series 3900]
NOTE: Set the second data to 0 when measuring traffic data continuously per hour/day.
470 Send Backward GB signal when terminating to Attendant Con-
sole on DID MFC call
[Not used in North America]
471 Send Backward GB signal when terminating by tandem con-
nection or converting received digits on DID MFC call
[Not used in North America]
472 Request ANI signal/Caller ID from network when incoming
call terminates
473 Connecting method when receiving Backward Signal meaning
Line Busy/Unallocated No./Congestion on DOD MFC call
[Not used in Australia/North America]
474 Send ANI signal to PSTN on DOD MFC call/Enhanced 911
BASIC SERVICE FEATURES
0 To clear
1 Not cleared
0 SMFN STS=7
1 SMFN STS=0
0 To send
1 Not sent
0 Available
1 Not available
0 Available
1 Not available
0 Same as 2400 IPX system (recom-
mended setting)
1 SMFN Off-Hook indication sent
0 SCF error Detail
1 SCF error Kind
0 To readout from the newest data
1 To readout from the oldest data
0 Called station control
1 Called station idle (charge)
0 Called station control
1 Called station idle (charge)
0 Available
1 Not available
0 Not released trunk
(Tone/Announcement from C.O.)
1 Release trunk
(BT/ROT from PBX)
0 To send
1 Not sent
– 119 –
: Initial Data
SETTING DATA
Continued on next page
NWA-008844-001 Rev.5.0
91ch3001.fm
JUNE/01/2007
CM08