NEC Univerge NEAX 2000 IPS Command Manual page 891

COMMAND CODE TITLE:
DD01
DATA
229 Maximum accumulation rate of billing memory for external
alarm output when the rate exceeds assigned value
NOTE 1: The condition for external alarm is as follows;
(a) The accumulation rate for the following limit value approaches the value set by
(b) The accumulation rate for the following limit value approaches full.
(c) The accumulation rate for the following limit value is less than the assignable range set by
[Limit Value]
- Limit value of remaining Call Record memory set by CMDD02>0/1/2
NOTE 2: ON/OFF control for external relay on DK00 card and fault information display can be performed
with the condition for external alarm as above.
For case (a): External relay ON/OFF set by CMDD00>126
For case (b): External relay ON/fault information display set by CMEA Y=2>28
For case (c): External relay OFF/fault information display set by CMEA Y=2>38
239 Direction for sending of Centralized Billing information from
local office
NOTE 1:
Assign 0 for local office and assign 1 or 2 for center office.
NOTE 2: The billing information is sent to SMDR terminal with NEAX 2400 IMS Format.
SMDR/MCI/PRINTER FOR PMS FUNCTIONS
1ST DATA
FUNCTION
CMDD01>229 in advance.
CMDD01>229 or is cleared the stored billing memory.
Fault information display set by CMEA Y=2>28
50-99: 50%-99%
80
0 : Not Centralized Billing office
1 : SMDR terminal 0 (Center office)
2 : SMDR terminal 1 (Center office)
– 867 –
: Initial Data
2ND DATA
: 80%
(Local office)
NWA-008844-001 Rev.5.0
CMDD01
91ch3009.fm
JUNE/01/2007