[Cm60] Att Tenant Group, Functions - NEC Univerge NEAX 2000 IPS Command Manual

COMMAND CODE TITLE:
60
FUNCTION:
This command is used to assign a number to an Attendant Console for access on a tenant basis, and de-
fine the consoles' night switching ability, off-hook ringing, tone ringer, password code for Attendant
Lockout and Attendant Programming.
PRECAUTION:
(1) After setting CM60 Y=00, 01, 02, 04, 06, 22, system reset is required.
(2) The data for each Attendant Console type is shown below.
Y
KIND OF
ATTCON
Large type ATTCON
ATTCON/DESKCON
*: CM60 Y=23 is only available for DESKCON.
(3) When assigning a password code for ATTCON/DESKCON by CM60 Y=30, the Function number
(0/1) is required as the first data. The purpose of Function numbers is shown below.
0: To assign a password for Attendant Lockout
1: To assign a password for Attendant Programming the following features:
Remote Access to System (DISA), Speed Calling-System (System Speed Dialing), Date and
Time, Choice of Night Service and Tone Ringer
ASSIGNMENT PROCEDURE:
ST + 60YY + DE
+ 6030 + DE
ST
ATT TENANT GROUP, FUNCTIONS
00 01 02 04
× × × ×
× × × ×
ATTCON FUNCTION
+
NUMBER NUMBER
(0-7) (0/1)
FUNCTION
+ + DE
NUMBER
(0/1)
06 16 17 22 23
×
– – –
× × × × ×*
DATA
+ DE +
(1-8 digits)
DATA
+ +
EXE
(1-8 digits)
– 489 –
×: To assign –: Not assigned
26 27 30 32
×
– – – –
× × ×
–
+ EXE
NWA-008844-001 Rev.5.0
CM60
33 34
– –
× ×
91ch3005.fm
NOVEMBER/15/2006