NEC Univerge NEAX 2000 IPS Command Manual page 370

COMMAND CODE TITLE:
35
(3) When assigning a Tie line, the data in CM35 Y=09 (Incoming connection signalling) should be
similar to that of CM35 Y=20 (Sender starting condition).
The table below shows the assignment of the sender starting condition in relation to the incoming
connection signalling.
INCOMING CONNECTION
SIGNALING (CM35 Y=09)
Ground Start (01)
Loop Start (15)
Wink Start (03)
Delay Dial (04)
Immediate (05)
2nd DT/Timing (06)
NOTE: ( ) indicates the data to be assigned.
(4) Table below shows the value of C.O, LD and DID trunk Gain PAD assigned by CM35 Y=47,
Data=0-3 (T: Transmitter PAD (dB), R: Receiver PAD (dB)).
CM35 Y=47 DATA
0
1
2
3
(5) After setting CM35 Y=100, system reset is required.
After setting CM35 Y=113, DCH card reset is required.
After setting CM35 Y=142, DBM card reset is required.
ASSIGNMENT PROCEDURE:
+ 35YY/YYY +
ST
TRUNK ROUTE DATA
Ground Start (02)
Loop Start (15)
Wink Start (00)
Delay Dial (01)
Timing Start (15)
Timing Start (15)
COT (T/R)
+1.5/6.5
None
None
+0.5/+5.5
TRUNK
+ +
DE ROUTE DE
(2 digits)
SENDER START CONDITION
(CM35 Y=20)
LDT/DID (T/R)
+1.5/6.5
0/0
+0.5/+2.5
+0.5/+5.5
DATA
+ +
EXE
(1-4 digits)
– 346 –
CM35
REMARKS
REMARKS
NWA-008844-001 Rev.5.0
91ch3003.fm