NEC Univerge NEAX 2000 IPS Command Manual page 537

COMMAND CODE TITLE:
67
Y
No. MEANING
17 Maximum value of
jitter buffer for
each location
group
NOTE 1: Assign the value which exceeds the minimum value of jitter buffer set by CM67 Y=16.
NOTE 2: When using Series 3200 R6.2 (R6.2) software or later, set the maximum value of jitter buffer by CM67
Y=05.
18 IP-PAD group
number
[Series 3100]
NOTE: This data is available only for the IP-PAD (PN-32IPLA/PN-32IPLA-A).
19 Priority of IP-PAD
channel
[Series 3100]
NOTE 1: When no 16VCT card is mounted, set the 2nd data 00 or 02.
NOTE 2:
When using the IP-PAD card or IP-PAD channel with CODEC/IP-PAD channel without CODEC
properly to each terminal, set the IP-PAD group number combining with location number.
NOTE 3:
When using only PN-8IPLA (IP-PAD) card in the system, follow the initial data setting. When using
PN-8IPLA (IP-PAD) card and PN-32IPLA/PN-32IPLA-A (IP-PAD) card in the system. You must not
set the second data to 02 (Use only IP-PAD channel without 16VCT). PN-8IPLA card is equal to the
IP-PAD channel with 16VCT.
LOCATION DATA ASSIGNMENT
1ST DATA
DATA MEANING
00 Location number
63
00 Location number
63
00 Location number
63
2ND DATA
DATA MEANING
01 10 ms.
30 300 ms.
(10 ms. increments)
NONE 300 ms.
CCC Clear
00 IP-PAD group number 00
31 IP-PAD group number 31
NONE IP-PAD group number 00
CCC Clear
00 Give priority to IP-PAD
channel without 16VCT
01 Give priority to IP-PAD
channel with 16VCT
02 Use only IP-PAD channel
without 16VCT
NONE Use only IP-PAD channel
with 16VCT
CCC Clear
– 513 –
CM67
: Initial Data
RELATED
COMMAND
CM12 Y=39
CM8A Y=5000-
5255: 173
CM0A Y=09
CM0A Y=70
CM12 Y=39/50
CM8A Y=5000-
5255: 173
CMAD Y=29
CM12 Y=39/50
CM8A Y=5000-
5255: 173
CMAD Y=29
Continued on next page
NWA-008844-001 Rev.5.0
91ch3005.fm