NEC Univerge NEAX 2000 IPS Command Manual page 736

COMMAND CODE TITLE:
DB
Y
No. MEANING
90 Caller ID Receiver
Memory All Clear
91 Caller ID Receiver
Memory Clear for
Development Table
No. assigned by
CMDC and Develop-
ment Data assigned by
CMDB
92 Caller ID Receiver
Memory Clear for
Development Data
assigned by CMDB
NOTE 1: If assigning the destination station number as below, the terminating system overrides CM30
Y=02/03 for the selected Development Table.
****02: Trunk Line (Direct) Appearance
****03: Trunk Line (Direct) Appearance + TAS
****04: Direct-in Termination
****09: Automated Attendant
****11: Attendant Console + Trunk Line Appearance
****13: TAS
****14: Attendant Console
****16: Remote Access to System (DISA)
****31: DID, Tie Line, and the call which is not handled by the PBX
NOTE 2: Destination station number can be LCR access code + outside telephone number.
CALLING NUMBER DEVELOPMENT DATA
1ST DATA
DATA MEANING
0000 –
0001
0002
DATA
CCC
– 712 –
2ND DATA
MEANING
Clear
NOTE: Before clearing the data, set
the SW1-1 to SW1-4 on the
CALLER ID Receiver Trunk
to "ON" (Make-busy); and
after memory clear, restore
them to "OFF".
NWA-008844-001 Rev.5.0
CMDB
91ch3008.fm