NEC Univerge NEAX 2000 IPS Command Manual page 398

COMMAND CODE TITLE:
35
Y
No. MEANING
256 Whether the call terminat-
ing method is specified for
incoming call with no CLI in
Night Mode/Mode A/
Mode B
[Series 3600]
NOTE: Assign the call terminating method by CM35 Y=257 when this command is set to 0/1.
257 Specification of the call ter-
minating method for incom-
ing call with no CLI in Night
Mode/Mode A/Mode B
[Series 3600]
258 Distinctive LED indication
term
on D for incoming call
with no CLI
[Series 3600]
NOTE: This command is effective on the following conditions.
• CM35 Y=32 is set to 1.
• CM35 Y=255, 257 are set to 0 or 2, and D
265 Screening Indicator (ISDN
Calling party number)
[Series 3500]
266 Relay of the ALERT mes-
sage to the calling party in
tandem connection (ISDN to
ISDN)
[Series 3600]
NOTE 1: This command should be set to both incoming trunk route and outgoing trunk route of tandem office.
NOTE 2:
To send tone to the calling party according to the status of calling party (idle or busy) as shown below,
set the second data of CM35 Y=233 and CM35 Y=266 to "0".
• RBT is sent when the calling party is idle.
• BT is sent when the calling party is busy.
NOTE 3: Set the second data 0 to the incoming and forwarding trunk route of Mobility Access.
TRUNK ROUTE DATA
DATA
0 Specified when reason of the incoming call with
no CLI is "Privacy"
1 Specified for all incoming call with no CLI
3 Not specified
0 To transfer to the DAT/another station/Atten-
dant Console (assigned by CM51 Y=33)
1 To reject the call termination
2 To terminate the D
cation (assigned by CM35 Y=258)
3 To terminate as usual
0 Green (120 IPM)
1 Red (120 IPM)
3 Network provided
NONE No data
0 To provide
1 Not provided
SETTING DATA
MEANING
term
with unusual LED indi-
term
receives the incoming call.
– 374 –
CM35
: Initial Data
RELATED
COMMAND
CM35 Y=257
CM35 Y=256, 258
CM51 Y=33
CM35
Y=32, 255, 257
CM35 Y=233
Continued on next page
NWA-008844-001 Rev.5.0
91ch3003.fm
JANUARY/20/2006