NEC Univerge NEAX 2000 IPS Command Manual page 151

COMMAND CODE TITLE:
08
BASIC SERVICE FEATURE: 600-699
BASIC SERVICE FEATURE
600 Selection of trunk route seized for Call Forwarding-All Calls/
Busy Line/Don't Answer (No Answer)-Outside, Split Call For-
warding-All Calls/Busy Line/Don't Answer (No Answer)-Out-
side
602 Reset of Queue Limit counter for TAS per tenant
603 Caller ID/CPN/ANI to Single Line Telephone from CCIS
606 Link Reconnect-CCIS
607 Reconnect the CCIS link when a call is connected to UCD
Delay Announcement via CCIS
608 Call Forwarding type when an incoming call terminates via
CCIS
614 When IP trunk of originating office in CCIS over IP connection
(Point-to-Multipoint connection) cannot connect with a net-
work, a non-trunk correspondence message is sent to destina-
tion office via other IP trunk
[Series 3200 R6.2 (R6.2)]
NOTE 1:
Non-trunk correspondence message is the message sent to destination office when the following ser-
vice is provided.
Call Back-CCIS
Centralized Billing-CCIS
Centralized Day/Night Mode Change-CCIS
Message Waiting Lamp Setting-Attendant/Station-CCIS
Voice Call-CCIS
Centralized MAT-CCIS
Fault Message
Busy Lamp Field (BLF)-CCIS
Voice Mail Integration-CCIS
NOTE 2: This service is effective only for CCIS over IP connection (Point-to Multipoint connection) using IPT
card.
NOTE 3:
This service is necessary to set other destination CCH as seizure sequence by CMA7 Y=63.
BASIC SERVICE FEATURES
0 By calling party's tenant/terminating
trunk's tenant
1 By Call Forwarding setting station's
tenant
0 Not provided
1 To provide
0 To provide
1 Not provided
0 Not provided
1 To provide
0 To provide
1 Not provided
0 As per CM65 Y=37/38/39
1 As per CM65 Y=23/24/25
0 To send
1 Not sent
– 127 –
: Initial Data
SETTING DATA
Continued on next page
NWA-008844-001 Rev.5.0
91ch3001.fm
JULY/01/2006
CM08