NEC Univerge NEAX 2000 IPS Command Manual page 49

CONDITION
Commands which require a
reset of the MP card after
data setting.
• Press SW1 on the MP
card for system reset.
NOTE 1
INITIAL
NOTE 1: Before the MP card is reset, the system data backup must be executed by CMEC Y=6>0:0.
NOTE 2: A reset is not required after setting/changing CM04 Y=00, CM12 Y=17, and CM35 Y=100,
when using Series 3600 software or later. These commands are valid by the following opera-
tions respectively after setting/changing.
• CM04 Y=00 : pull out and reconnect the modular connector of the D
• CM12 Y=17 : pull out and reconnect LLC card
• CM35 Y=100: pull out and reconnect COT/IDT/LDT/ODT/DID cards
Conditions for Using Commands
COMMANDS
CM04 Y=00 NOTE 2
CM05
CM06
CM07
CM08>335, 368, 390, 391,
392, 396, 397, 420, 477,
478, 487
CM09
CM0B
CM10
CM12 Y=17 NOTE 2
CM13 Y=33
CM14
CM30 Y=35
– 25 –
CHAPTER 2 PRECAUTION
CONDITIONS FOR USING COMMANDS
MEANINGS
Language Indicated on D
DESKCON LCD
AP Card Type
AP Card Allocation
DTI/CCIS/ISDN Trunk Assignment
Basic Service Features
Additional Service Features
LAN Data Assignment
Station Number, Trunk Number, Card Num-
ber (The system initialization is required only
for assigning the PN-CFT.)
Station Class-1
Station Class-2
Station Number, Trunk Number, Card Num-
ber (The system initialization is required only
for assigning the PN-CFT/WLAN virtual CS/
ZT.)
Trunk Data
term
/ATTCON/
term
and DLC card
Continued on next page
NWA-008844-001 Rev.5.0
91ch2001.fm
DECEMBER/02/2005