NEC Univerge NEAX 2000 IPS Command Manual page 126

COMMAND CODE TITLE:
08
BASIC SERVICE FEATURE
208 Dialing of a Single Digit Feature Access Code, while the calling
station hears busy tone
To activate Single Digit Feature Access Code, set CM08>050, 051, 069 and 148 to "1".
050 If the * button on a DTMF telephone is pressed while hearing busy tone, it is
regarded as a Switch Hook Flash
051 If the # button on a DTMF telephone is pressed while hearing busy tone, it is
regarded as a Switch Hook Flash
069 When a station user has dialed any one digit while hearing busy tone
148 When a station user, upon encountering the called station busy, has dialed
the same last digit again hearing busy tone
The table below shows the available features and its access codes for Single Digit Feature Access Code, while
the calling station hears busy tone.
Access
Code
2 Call Back/Outgoing Trunk Queueing
(Trunk Queuing-Outgoing)
3 Executive Right of Way
(Executive Override)
4 Station Camp-On
(Camp-ON)
5 Call Waiting
6 Message Reminder/Message Waiting
Set
7 Step Call
(7 + Last one digit)
8 Message Waiting Record
NOTE 1: While the D
NOTE 2: While the DTMF telephone is holding the other call, this feature is not available.
BASIC SERVICE FEATURES
Service
Feature
term
or DP telephone is holding the other call, this feature is not available.
0
1
Calling Station Kind
Attendant
term
D
Console
Not Available
available NOTE 1
Not Available
available NOTE 1
Available Available
Available Available
Available Available
Available Available
Available Available
– 102 –
: Initial Data
SETTING DATA
Available
Not available
1 Ineffective
1 Ineffective
1 Step Call
1 Ineffective
DP
Telephone Telephone
Available Available
NOTE 1
Available Available
NOTE 1
Available Available
Available Available
Available Available
Available Available
Available Available
Continued on next page
NWA-008844-001 Rev.5.0
CM08
DTMF
NOTE 2
NOTE 2
NOTE 2
NOTE 2
NOTE 2
NOTE 2
NOTE 2
91ch3001.fm