NEC Univerge NEAX 2000 IPS Command Manual page 51

CONDITION
Commands which require a
reset of the AP00 card after
data setting.
• Set the Make Busy switch
to UP and then DOWN.
AP00 INITIAL
Commands which require a
reset of the DCH card after
data setting.
• Set the Make Busy switch
to UP and then DOWN.
DCH INITIAL
Commands which require a
reset of the ICH card after
data setting.
• Set the Make Busy switch
to UP and then DOWN.
ICH INITIAL
Commands which require a
reset of the DTI/PRT/CCT
card after data setting.
• Set the Make Busy switch
to UP and then DOWN.
DTI INITIAL
Conditions for Using Commands
COMMANDS
CM12 Y=49
CMD001>20-35, 80-96,
100, 102-107, 109-116,
120, 122-127, 131-136,
140, 142-147, 149-156,
250, 257, 258
CMDD00>3
CMDD01>100-103
CMDD10
CM35 Y=113, 142
CMA9
CMAA Y=06
CMAA Y=06>24, 63
CM08>644
CMAA Y=00, 01, 02, 03,
06, 09, 12, 13
– 27 –
CHAPTER 2 PRECAUTION
CONDITIONS FOR USING COMMANDS
MEANINGS
Station Class-1
SMDR/CIS/PMS Function
SMDR Functions (1)/Do Not Disturb Group
Set/Cancel
SMDR/MCI Functions
Interface Condition for AP00 RS Port
Trunk Route Data
D-channel Assignment
ISDN Protocol Type for DCH/PRT
ISDN Terminal Type for ICH
Basic Service Features
DTI/PRT/CCT Functions
Continued on next page
NWA-008844-001 Rev.5.0
91ch2001.fm
DECEMBER/02/2005