Notice On Cat Mode - NEC Univerge NEAX 2000 IPS Command Manual

NOTICE ON CAT MODE

(1) The CAT is used in on-line. Therefore, system data clear commands (CM00, CM01) cannot be
accessed from the CAT.
(2) To use the CAT after clearing all system data, perform the following operations on the system.
1. Plug a DLC card into the LT00 slot of PIM0.
2. Connect the CAT (D
3. Set SW3 on the MP card to "B".
4. Press SW1 on the MP card. (System Data All Clear)
5. Set SW3 on the MP card to "0". (On-Line mode)
6. Set the CAT mode on the D
(3) Do not change or delete CM10/CM14 My Line number of the CAT, during CAT mode.
(4) There are no limitations on the number of D
capability. However, the number of D
two.
If no key operation is executed for about 10 minutes, the CAT mode is canceled.
(5) When you use a D
to 24-digit.
term
NOTE 1: D 70=Elite Terminal
term
D 75=D
term
D 85=D
NOTE 2: Do not use
quired.
term
) to LEN000 at the MDF.
term
.
term
term
70/75 for CAT, press
term
Series E
term
Series i
( ) key in the above (5) operation.
ST REDIAL
term
s in the system that can be programmed to allow CAT
s that can be placed into CAT mode, at the same time, is
(Exit) key so that the display of CAT is expanded
ST
– 15 –
CHAPTER 1 HOW TO USE CAT
NOTICE ON CAT MODE
(Exit) key operation is re-
ST
NWA-008844-001 Rev.5.0
91ch1001.fm