NEC Univerge NEAX 2000 IPS Command Manual page 747

COMMAND CODE TITLE:
E6
Y MEANING
06 Call Forwarding-PS/WLAN Termi-
nal Out of Cell (Zone)
[Series 3100]
Call Forwarding-Logout (D
[Series 3100]
07 Timing of Call Forwarding-Don't
Answer (No Answer) for a trunk
incoming call on a station basis
[Series 3200 R6.2 (R6.2)]
08 Timing of Call Forwarding-Don't
Answer (No Answer) for an internal
call or an assisted call on a station
basis
[Series 3200 R6.2 (R6.2)]
50 Trunk number link up with a
Mobility Access station number
[Series 3700 R12.1]
NOTE 1:
Station number cannot be assigned to second data.
NOTE 2: When the mobile phone number has been already assigned to other station number, "ASSIGNED
ALREADY" is displayed.
NOTE 3: Outgoing Trunk Access Code (1-4 digits) must be assigned by CM64 Y=10.
NOTE 4: When the system operates both CME6 Y=50 and CME6 Y=51, set the same number of the 2nd data of
CME6 Y=51 as the 2nd data.
51 Destination of ISDN Alternative
Routing of in Remote PIM survival
mode (station basis)
[Series 3700 R12.2]
NOTE 1: When the system operates both CME6 Y=50 and CME6 Y=51, set the same number of the 2nd data of
CME6 Y=50 as the 2nd data.
NOTE 2: When 2nd data of CM64 Y=12 is set to "0", the destination is set by this command.
CALL FORWARDING SET/RESET FROM MAT/CAT
• Destination=Extension;
X-XXXXXXXX: Station No. (1-8 digits)
• Destination=Outside party;
term
IP)
X-XXXX +
X-XXXX: Outgoing Trunk Access Code (1-4 digits)
,
YY...YY : Called No. (Maximum 26 digits)
• Destination=Attendant; E000
NONE
001: 0-4 seconds
(4 seconds increments)
120: 116-120 seconds
NONE
001: 0-4 seconds
(4 seconds increments)
120: 116-120 seconds
NONE
• Trunk number=Mobile phone No. (Maximum 26 digits)
NONE
• Destination C.O. line number (Maximum 26 digits)
NONE
DESTINATION
,
+ YY...YY
: Separate Mark
: No data
: As per CM41 Y=0>100
: As per CM41 Y=0>101
: No data
: No data
– 723 –
CME6
: Initial Data
NWA-008844-001 Rev.5.0
91ch3008.fm
JULY/01/2006