NEC Univerge NEAX 2000 IPS Command Manual page 122

COMMAND CODE TITLE:
08
BASIC SERVICE FEATURE
156 Dialing of a Single Digit Feature Access Code while the calling
station hears RBT, or performs a Voice Call
The table below shows the available features and its access codes for Single Digit Feature Access Code, while
the calling station hears RBT.
Access
Code
1 Voice Call
2 Call Back-Don't
Answer
6 Message Reminder/
Message Waiting Set
8 Message Waiting
Record
NOTE 1:
While the D
NOTE 2: While the DTMF telephone is holding the other call, this feature is not available.
157 Whether the Paging Answer code and the Paging Access code
are to be the same or not.
If codes are the same, paging access codes must be set to trunk
routes (in CM30 Y=00), as follows:
Paging Answer Zone 0: Trunk Route 50
CM20>A070-A079, are used to set the combined access/
answer codes.
NOTE: The second data must be set to 0 when one Paging trunk is connected with the multiple AMP relay cir-
cuits or one Paging trunk is connected with two AMP relay circuits simultaneously.
158 All Zone Internal Paging
BASIC SERVICE FEATURES
Service
Attendant
Feature
Console
Available
Not
Available
Available
Available
term
or DP telephone is holding the other call, this feature is not available.
9: Trunk Route 59
See CM56 Y=00-05 CM20>A164
0 Available
1 Not available
Calling Station Kind
DP
term
D
Telephone
Available Available
Available Available
NOTE 1 NOTE 1
Available Available
Available Available
0 Same
1 Different
0 Not available
1 Available
– 98 –
: Initial Data
SETTING DATA
DTMF Telephone
Available after Hooking
NOTE 2
Available after Hooking
NOTE 2
Available after Hooking
NOTE 2
Available after Hooking
NOTE 2
See CM20>A070-A079
CM30 Y=28
CM44>02XX
Continued on next page
NWA-008844-001 Rev.5.0
91ch3001.fm
JUNE/01/2007
CM08