NEC Univerge NEAX 2000 IPS Command Manual page 684

COMMAND CODE TITLE:
B0
NOTE 1:
Meaning of display (TRUNK STATUS DATA)
B01>XXX: Y Y
1 2
• XXX=Trunk No.: 000-255
• Y =0; No Trunk Make Busy
1
1; Trunk Make Busy
2; No trunk card
• Y =0/1; Normal/Fault=Line status (Broken wire/short circuit)
2
• Y =0; Not used
3
• Y =0; Not used
4
• Y =0/1; Normal/Fault=Line status (Metering Burst)
5
NOTE 2: Meaning of display (TRUNK STATUS DATA)
B01>600: Y Y Y
1 2
• Y =1; Indication of Line fault alarm on MN lamp
1
• Y =1; Indication of Line fault alarm on MJ lamp
2
• Y =1; Indication of Line fault alarm on Large type ATTCON MN lamp
3
NOTE 3: The meaning of the data displayed is as shown below.
0: Not started
1: Under measuring
2: Finished
After turning power on or after a system reset, the system starts the PEG COUNT, if the PEG
COUNT start time has not been set.
PEG COUNT
Y Y Y -
3 4 5
-
3
– 660 –
CMB0
NWA-008844-001 Rev.5.0
91ch3007.fm
NOVEMBER/15/2006