Quick Exit; Exit Delay Extension; Bypassing Sensors - Interlogix Simon XTi-5 User Manual

4. Press your desired arming level. The arming countdown begins.
The screen displays
and speaks Doors and Windows On, No Entry Delay.
Note: To avoid causing an alarm, you must disarm the system with a wireless
keyfob before entering your home.

Quick exit

Use the quick exit feature when you want to briefly leave the house while the
system is stilled armed (for instance to get the newspaper). This feature must be
enabled by your installer.
To enable Quick Exit:
1. Press PRESS TO DISARM.
2. Press on the touch screen.
This will start a 2 minute timer that will allow a designated exit door to be open
and closed once without triggering an alarm.
Note: The designated door may be opened and closed only once. If you close
the designated door behind you when you exit, you will need to disarm the
system upon re-entering. Leave the designated door open while using the quick
exit feature.

Exit delay extension

If enabled by your installer, the exit delay extension feature will recognize when
you arm the system, leave your house and then quickly re-enter (for example, if
you forget your car keys). If this happens, the system will restart your exit delay
to give you the full exit delay again.

Bypassing sensors

Bypassing a sensor allows you to open the sensor while the system is armed.
For example, if your doors and windows are armed and you want to open your
kitchen window, but do not want to disarm the entire system, you can bypass the
kitchen window sensor and then open the kitchen window without causing an
alarm. Bypassed sensors are automatically unbypassed when the arming level is
changed to a level where the sensor is not active.
To bypass, or unbypass, a sensor:
1. Press .
2. Press SELECT
3. Enter your master code.
Simon XTi-5 User Manual
(clock with a red strike through) with your arming level
.
11