1A-6 HEATER AND VENTILATION
INSTALLATION
1) Reverse removal procedure for installation.
2) Enable air bag system, if equipped.
Refer to ENABLING AIR BAG SYSTEM in Section 10B.
BLOWER MOTOR RESISTOR
INSPECTION
Measure each terminal-to-terminal resistance on resistor.
Resistance H – Mh : Approx. 0.6 Ω
Mh – Ml: Approx. 1.0 Ω
Ml – L : Approx. 1.8 Ω
If measured resistance is incorrect, replace heater blower motor re-
sistor.
REMOVAL
1) Disconnect negative (–) cable at battery.
2) Disable air bag system, if equipped.
Refer to DISABLING AIR BAG SYSTEM in Section 10B.
3) Remove clutch pedal bracket (RH steering vehicle), if neces-
sary.
Refer to "CLUTCH PEDAL" in Section 7C.
4) Disconnect resistor coupler.
5) Remove blower motor resistor (1).
INSTALLATION
1) Reverse removal procedure for installation.
2) Enable air bag system, if equipped.
Refer to ENABLING AIR BAG SYSTEM in Section 10B.