Removing The T320 Sibs; Figure 44: Removing A Power Supply Before Installing The Router - Juniper Core Router T Series Hardware Manual

T320 Core Router Hardware Guide
See Also

Removing the T320 SIBs

132
Grasp the handle on the power supply faceplate and pull firmly to start removing the
5.
power supply. Slide it halfway out of the chassis (see
Place one hand underneath the power supply to support it and slide it completely out
6.
of the chassis.
CAUTION: Each power supply weighs approximately 12 lb (5.4 kg). Be
prepared to support the full weight of the power supply as you remove it
from the router.
Repeat the procedure for the other power supply.
7.

Figure 44: Removing a Power Supply Before Installing the Router

Preventing Electrostatic Discharge Damage to a T320 Router on page 330
T320 Power System Description on page 83
T320 Power System Electrical Specifications on page 96
Three SIBs are installed in the router. The SIBs are located in the rear of the chassis in
the slots marked through
SIB0
To remove the SIBs (see Figure 45 on page
Place an electrostatic bag or antistatic mat on a flat, stable surface.
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to one of the ESD points on the chassis. For more information about ESD,
see "Preventing Electrostatic Discharge Damage to a T320 Router" on page
Figure 44 on page
. Each SIB weighs approximately 4.5 lb (2.0 kg).
SIB2
133):
Copyright © 2018, Juniper Networks, Inc.
132).
330.