Removing The M320 Sibs; Figure 43: Removing A Sib - Juniper M320 Hardware Manual

Removing the M320 SIBs

Copyright © 2015, Juniper Networks, Inc.
Two to four SIBs are installed in the router. The SIBs are located in the rear of the chassis
in the slots marked SIB0 through
SIB weighs approximately 4 lb (1.8 kg).
To remove a SIB (see Figure 43 on page
Place an electrostatic bag or antistatic mat on a flat, stable surface.
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to an approved site ESD grounding point. See the instructions for your site.
Loosen the captive screws (using a Phillips (+) screwdriver, number 2) on the ejector
3.
handles on each side of the SIB faceplate.
Flip the ejector handles outward to unseat the SIB.
4.
Grasp both ejector handles, pull firmly, and slide the SIB about three-quarters of the
5.
way out of the chassis.
Place one hand underneath the SIB to support it, and slide it completely out of the
6.
chassis. Place it on the antistatic mat.
CAUTION: Do not stack hardware components on one another after you
remove them. Place each component on an antistatic mat resting on a
stable, flat surface.

Figure 43: Removing a SIB

Chapter 18: Installing the M320 Without a Mechanical Lift
SIB3 . SIBs are hot-insertable and hot-removable. Each
145):
145