Logging Version - Dell C9000 Series Reference Manual

Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
Usage Information To block a type of message parameter, set the logging trap level to a lower number. For
example, to block severity messages at level 6, set the level to 5.
Related
logging
Commands
logging on

logging version

Displays syslog messages in a RFC 3164 or RFC 5424 format.
C9000 Series
Syntax
logging version {0|1}
Defaults
0
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.5(0.1)
9.5(0.0)
Usage Information To display syslog messages in a RFC 3164 or RFC 5424 format, use the log version
command in configuration mode. By default, the system log version is set to 0.
The following describes the two supported log messages formats:
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series, S55.
Introduced on the C-Series.
— enables the logging to another device.
— enables logging.
Description
Introduced on the Z9500.
Introduced on the S4810, S4820T, S6000, Z9000, and MXL.
• 0 – Displays syslog messages format as described in RFC 3164, The BSD syslog
Protocol
Simple Network Management Protocol (SNMP) and Syslog 2086