Default Logging Trap - Dell S4810 Reference Manual

E-Series legacy
command
Related
logging monitor
Commands
terminal monitor

default logging trap

Return to the default settings for logging messages to the Syslog servers.
S4810
Syntax
default logging trap
Defaults level = 6 or informational
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command
Related logging trap
Commands
logging
Configure an IP address or host name of a Syslog server where logging messages are sent. Multiple
logging servers of both IPv4 and/or IPv6 can be configured.
S4810
Syntax
logging {ip-address | ipv6-address | hostname} {{udp {port}} |
{tcp {port}} [vrf vrf-name]
1584
— sets the logging monitor parameters.
— sends system messages to the terminal/monitor.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
— limit messages logged to the Syslog servers based on severity.
Simple Network Management Protocol (SNMP) and Syslog