Snmp-Server Engineid - Dell Z9500 Reference Manual

snmp-server engineID

Configure the name for both the local and remote SNMP engines on the router.
Z9500
Syntax
snmp-server engineID [local engineID] [remote ip-address udp-
port port-number engineID]
To return to the default, use the no snmp-server engineID [local
engineID] [remote ip-address udp-port port-number engineID]
command.
Parameters
local engineID
remote ip-
address
udp-port port-
number
engineID
Defaults As above.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
Simple Network Management Protocol (SNMP) and Syslog
Enter the keyword local followed by the engine ID number
that identifies the copy of the SNMP on the local device.
Format (as specified in RFC 3411): 12 octets.
• The first four octets are set to the private enterprise
number.
• The remaining eight octets are the MAC address of the
chassis.
Enter the keyword remote followed by the IP address that
identifies the copy of the SNMP on the remote device.
Enter the keywords udp-port followed by the user
datagram protocol (UDP) port number on the remote device.
The range is from 0 to 65535. The default is 162.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
1667