Dcbx Port-Role - Dell C9000 Series Reference Manual

The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.7(0.1)
9.7(0.0)
9.0.2.0
8.3.19.0
8.3.12.0
8.3.16.0
Usage Information You can configure the transmission of more than one TLV type at a time; for example:
advertise dcbx-tlv ets-conf ets-reco.
You can enable ETS recommend TLVs (ets-reco) only if you enable ETS configuration
TLVs (ets-conf). To disable TLV transmission, use the no form of the command; for
example, no advertise dcbx-tlv pfc ets-reco.
DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.
Configure DCBX operation at the INTERFACE level on a switch or globally on the
switch. To verify the DCBX configuration on a port, use the show interface dcbx
detail command.

dcbx port-role

Configure the DCBX port role the interface uses to exchange DCB information.
C9000 Series
Syntax
dcbx port-role {config-source | auto-downstream | auto-upstream |
manual}
To remove DCBX port role, use the no dcbx port-role {config-source |
auto-downstream | auto-upstream | manual} command.
Parameters
config-source |
auto-downstream
| auto-upstream |
manual
Description
Introduced on the C9010.
Introduced on the S3048-ON and S4048-ON.
Introduced on the S6000-ON.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.
NOTE: The advertise dcbx-tlv command is not supported on cascade
interfaces or extended ports.
Enter the DCBX port role, where:
• config-source: configures the port to serve as the
configuration source on the switch.
Data Center Bridging (DCB) 708