Configure EFM Bonding Management Provisioning
The NetVanta 800 Inband Management configuration is tied to the EFM bonding group.
Thus, when a NetVanta is replaced, the remote management configuration is pushed down so
that the NetVanta is immediately remote accessible when at least one DS3 link synchronizes.
NOTE
• If provisioning the NetVanta 800 locally, the Total Access 5000 overwrites
the Inband management provisioning when the DS3 ports synchronize
with the DS3 EFM access module.
• The Inband management of the NetVanta 800 is configured at the Total
Access 5000, and pus hed down to the NetVanta 800 as soon as
synchronization is achieved on one of the links of the bonded group.
To configure the EFM bonding group management provisioning, complete the following:
1. From the Enable prompt, type configure terminal , and press E
2. From the Global Configuration prompt, type interface efm-group <shelf/slot/
3. From the EFM Group Interface Configuration prompt, type subtended-host ip
4. From the EFM Group Interface Configuration prompt, type subtended-host s-tag
5. From the EFM Group Interface Configuration prompt, type subtended-host ip
6. From the EFM Group Interface Configuration prompt, type subtended-host ip
7. From the EFM Group Interface Configuration prompt, type subtended-host snmp-
8. From the EFM Group Interface Configuration prompt, type subtended-host snmp-
9. From the EFM Group Interface Configuration prompt, type subtended-host snmp-
10. From the EFM Group Interface Configuration prompt, type end , and press E
NOTE
This information is sent to the NetVanta 800 by way of an overhead
management channel.
65K510DEP08-1A
bal Configuration prompt.
, and press E
group>
NTER
address A.B.C.D E.F.G.H
IP address (A.B.C.D) and subnet mask (E.F.G.H).
, and press E
<1-4094>
NTER
default-gateway A.B.C.D
Gateway.
file-server default host A.B.C.D
Management TFTP server.
server chassis-id WORD
name.
server community read-only WORD
SNMP community.
server community read-write WORD
SNMP community.
return to the Enable prompt.
Section 6, EoTDM Provisioning - Create an EFM Bonding Group
to access the EFM Bonding Group Configuration prompt.
, and press ENTER to provision the NetVanta Management
to provision the NetVanta Management VLAN.
, and press E
to provision the NetVanta Management
NTER
, and press E
, and press E
NTER
to provision the NetVanta SNMP system
, and press E
, and press E
NTER
to access the Glo‐
NTER
to provision the NetVanta 800
to provision the read‐only
NTER
NTER
to provision the read‐write
NTER
to
6-9