Enable Network Interfaces
To enable any SM Gigabit‐Ethernet ports:
1. From the Enable prompt, type configure terminal and press E
2. From the Global Configuration prompt, type interface gigabit-ethernet
3. From the Gigabit Ethernet Interface Configuration prompt, type no shutdown , and
4. Repeat steps 2 to 3 to enable additional gigabit‐ethernet interfaces
5. From the Gigabit Ethernet Interface Configuration prompt, type end , and press E
Create a Link Aggregation Group
To create a link aggregation group and assign physical interfaces, complete the following
procedure:
1. From the Enable prompt, type configure terminal and press E
2. From the Global Configuration prompt, type interface lag-group 1/A/1 , and press
3. From the Link Aggregation Group Interface Configuration prompt, type active-
4. From the Link Aggregation Group Interface Configuration prompt, type link
5. Repeat step 4 to add all needed interfaces to the group.
6. From the Link Aggregation Group Interface Configuration prompt, type no shutdown
7. From the Link Aggregation Group Interface Configuration prompt, type end and press
8. From the Enable prompt, type show lag-group 1 , and press E
Enable LACP
To enable LACP for all active gigabit‐ethernet ports, complete the following procedure:
1. From the Enable prompt, type configure terminal and press E
2. From the Global Configuration prompt, type interface gigabit-ethernet <1/
65K510DEP08-1A
bal Configuration prompt.
, and press E
<shelf/slot/port>
Configuration prompt.
press E
NTER
to set the interface to In Service.
return to the Enable prompt.
bal Configuration prompt.
E
NTER
to create the link aggregation group and access the lag group configuration prompt.
links-minimum <1-n>
the group.
gigabit-ethernet <shelf/slot/port>
interface to the group.
and press E
NTER
to enable the link aggregation group.
E
NTER
to return to the Enable prompt.
aggregation groups in the system.
bal Configuration prompt.
, and press E
slot/port>
prompt.
Appendix A, Link Aggregation Guide - Link Aggregation Provisioning
to access the Gigabit Ethernet Interface
NTER
, and press E
NTER
to set the minimum number of active links for
, and press E
to access the Gigabit Ethernet Interface Configuration
NTER
NTER
to access the Glo‐
NTER
to access the Glo‐
NTER
to add a gigabit‐ethernet
NTER
to see the link
NTER
to access the Glo‐
NTER
to
A-3