Disable Ethernet Interfaces; Disable The Gigabit-Ethernet Interface - ADTRAN Total Access 5000 Deployment Manual

Disable Ethernet Interfaces

For each Ethernet port that is not in use for customer services, complete the following:
NOTE
This must be done to clear the Ethernet link down alarms.
1. From the Enable prompt, type configure terminal , and press E
2. From the Global Configuration prompt, access the unused Ethernet Port Configuration
3. Disable the Ethernet port down by typing shutdown , and press E
4. Repeat steps 2 and 3 for the remaining unused Ethernet ports.

Disable the Gigabit-Ethernet Interface

To disable the Gigabit‐Ethernet port, complete the following:
NOTE
A port must be placed out of service, regardless of SFP presence, to remove
the alarms.
If the port is enabled and no SFP is present, there will be an alarm for no SFP
being present.
1. From the Enable prompt, type configure terminal , and press E
2. From the Global Configuration prompt, access the Gigabit‐Ethernet Port Configuration
3. Disable the Gigabit‐Ethernet port by typing shutdown , and press E
The Gigabit‐Ethernet link down alarm should now be cleared in the alarm log, and the portʹs
LED should be off.
65K510DEP08-1A
Section 6, EoTDM Provisioning - Disable Unused NetVanta 800 Interfaces
bal Configuration prompt.
prompt by typing interface ethernet 1/0/<port> , and press E
The Ethernet link down alarm should now be cleared for this port in the alarm log, and
the portʹs LED should be off.
Once all unused Ethernet ports have been disabled, all Ethernet alarms should be cleared
in the alarm log.
bal Configuration prompt.
prompt by typing interface gigabit-ethernet 1/0/1 , and press E
NTER to access the Glo‐
.
NTER
NTER .
NTER to access the Glo‐
NTER .
NTER .
6-29