Provision the GE 4-Port Line Module
This subsection details the following information:
• Provision the GE 4‐Port Line Module Service State
• Provision the Network Ports
• Provision the Ethernet Star
• Provision for Redundancy
Provision the GE 4-Port Line Module Administration Status
Table J‐2 displays the three administration states and shows the equivalent Service State from
prior releases.
Command
no shutdown
shutdown maintenance
shutdown
To set the module administration state, complete the following:
1. From the Total Access 5000 Main menu, select System CLI , and press E
2. From the CLI menu, select CLI Command Entry , and press E
3. Select Y to enter the CLI command interface.
4. Log in again using the default ADMIN and PASSWORD options. The CLI prompt is
5. Type enable , and press E
6. From the Enable prompt, type configure terminal , and press E
7. From the Global Configuration prompt, provision the module administration state by
8. From the Global Configuration prompt, type interface gigabit-ethernet
65K510DEP08-1A
Appendix J, GigE Star Provisioning - Remote Terminal (RT) Provisioning
Table J-5. GE 4-Port Line Module Administration States
The following response id displayed:
Use EXIT to exit CLI session.
displayed.
performing one of the following commands:
• Type no slot shutdown <shelf/slot> , and press E
• Type slot shutdown maintenance <shelf/slot> , and press E
Out of Service, Maintenance
• Type slot shutdown <shelf/slot> , and press E
Unassigned
, and press E
<shelf/slot/port>
Previous
In Service
Out of Service, Main‐
tenance
Out of Service, Unas‐
signed
NTER
to enable the privileged commands.
NTER
.
Description
no shutdown
In the
state, traffic
passes and alarms are generated.
shutdown maintenance
In the
state, traffic passes but no alarms are
generated.
shutdown
In the
state, no traffic
passes and no alarms are generated.
.
NTER
NTER
.
NTER
.
NTER
to take a slot In Service
NTER
to take a slot
to take a slot Out of Service,
NTER
J-11