To redirect the EVCs to a Gigabit‐Ethernet port, complete the following procedure:
1. From the root prompt, type show evc , and press E
2. From the Enable prompt, type configure terminal , and press E
3. From the Global Configuration prompt, type evc <shelf/slot/index> , and press
4. From the EVC Interface Configuration prompt, type no connect men-port lag-
5. From the EVC Interface Configuration prompt, type connect men-port gigabit-
6. Type exit , and press E
7. Repeat steps 3‐6 as necessary.
Remove a Link Aggregation Group
To create a link aggregation group and assign physical interfaces, complete the following
procedure:
1. From the Enable prompt, type configure terminal and press E
2. From the Global Configuration prompt, type no interface lag-group 1/A/1 , and
3. From the Global Configuration prompt, type end , and press E
Provision Default Network Interface to SM A, Net 1
To configure the default network interface, complete the following procedure:
1. From the Enable prompt, type configure terminal , and press E
2. From the Global Configuration prompt, type ethernet default interface
3. From the Global Configuration prompt, type end and press E
65K510DEP08-1A
Appendix A, Link Aggregation Guide - Remove Link Aggregation Provisioning
Access 5000.
For any EVCs that are connected to the Gigabit‐Ethernet port, perform the following
steps to disconnect them from the GE port and connect them to the LAG group.
Global Configuration prompt.
E
NTER
to access the EVC Interface Configuration prompt.
, and press E
group 1/a/1
, and press E
ethernet 1/a/1
NTER
bal Configuration prompt.
press E
NTER
to delete the link aggregation group.
prompt.
bal Configuration prompt.
gigabit-ethernet 1/A/1
A, Net 1.
prompt.
NTER
to disconnect the EVC from the LAG group.
NTER
to connect the EVC to the newly created LAG group.
to return to the Global Configuration prompt.
, and press E
to set the default network interface to SM
NTER
NTER
to display all EVCs in the Total
NTER
to access the
NTER
to access the Glo‐
NTER
to return to the Enable
NTER
to access the Glo‐
to return to the Enable
NTER
A-7