Total Access 5000 Business Services Deployment Guide
Remove Link Aggregation Provisioning
To remove the link aggregation provisioning, complete the following procedure:
NOTICE
To remove cross connects from the aggregation bridge, reprovisioning is
required.
1. Disable LACP.
2. Provision the default network interface to none.
3. Redirect any created EVCs to the Network Gigabit‐Ethernet port.
4. Remove the Link Aggregation group.
5. Provision the default network interface to the SM A, Net 1.
6. Disable unused network interfaces.
7. Enable LACP.
Provision Default Network Interface to None
To configure the default network interface, complete the following procedure:
1. From the Enable prompt, type configure terminal and press E
2. From the Global Configuration prompt, type no ethernet default interface , and
3. From the Global Configuration prompt, type end and press E
Redirect EVCs
When a link aggregation group is disabled or removed, any service EVCs previously
connected to the link aggregation group must be redirected to the network Gigabit‐Ethernet
port.
NOTICE
If not redirected to the link aggregation group, the EVCs will be left hanging.
A-6
For more information, refer to "Disable LACP" on page A‐2.
For more information, refer to "Provision Default Network Interface to None" on
page A‐6.
For more information, refer to "Redirect EVCs" on page A‐6.
For more information, refer to "Remove a Link Aggregation Group" on page A‐7.
For more information, refer to ʺ"Provision Default Network Interface to SM A, Net 1" on
page A‐7.
For more information, refer to "Disable Network Interfaces" on page A‐8.
For more information, refer to "Enable LACP" on page A‐3.
bal Configuration prompt.
press E
to set the default network interface to None.
NTER
prompt.
NTER
to access the Glo‐
NTER
to return to the Enable
65K510DEP08-1A