Install The Sfps; 32-Port Shdsl Efm Description - ADTRAN Total Access 5000 Deployment Manual

Total Access 5000 Business Services Deployment Guide
8. Route the copper or optical cable to the cable tray located at the bottom of the module

Install the SFPs

!
CAUTION
Due to compliance certification requirements, only SFPs supplied by
ADTRAN are to be used with the Total Access 5000 modules. ADTRAN
cannot certify system integrity when non ADTRAN supplied SFPs are used.
To install an SFP into an appropriate module, complete the following:
1. Inspect the SFP for damage. If damaged, file a claim with the carrier and then contact
2. Insert the SFP into the SFP cage on the switch module, with the label from the
3. Remove the safety cap from the optical connectors of the SFP.
4. Insert the fiber connector into the SFP until it clicks into place.
!
CAUTION
Do not attempt to remove the SFP with the fiber installed.

32-Port SHDSL EFM Description

The 32‐Port SHDSL EFM provides 32 SHDSL links that can be bonded with Ethernet in the
first mile (EFM). Each SHDSL link is capable of data rates from 192 kbps to 5.7 Mbps in 64
kbps increments. For proper functionality, the 32‐Port SHDSL EFM must be installed in a Total
Access 5000 shelf that has a SM installed.
2-18
slots and dress with appropriate ties.
ADTRAN Customer Service.
manufacturer facing to the right. Slide the SFP all the way into the cage until it clicks into
place.
65K510DEP08-1A