S-tag
0, 1, 4095
2 – 4094
3072
Provisioning Steps
This process establishes a connection between the physical port and the virtual network.
To create the EVC, complete the following:
1. From the Enable prompt, type configure terminal , and press E
2. From the Global Configuration prompt, type evc <evc_name> , and press E
3. From the EVC Interface Configuration prompt, type s-tag <1-4094> , and press E
4. From the EVC Interface Configuration prompt, type connect men-port gigabit-
NOTE
The connect men‐port gigabit‐ethernet command entry applies to the active
GigE SM, independent of which GigE SM is actually specified, in an Active/
Standby configuration.
5. From the EVC Interface Configuration prompt, type connect men-port efm-group
NOTE
The EFM bonding group name can be used in lieu of the shelf/slot/group
designation.
6. From the EVC Interface Configuration prompt, type no shutdown and press E
7. From the EVC Interface Configuration prompt, type end and press E
65K510DEP08-1A
Function
Reserved
EVPLs and Inband Management VLAN
Internal Management VLAN (Default)
bal Configuration prompt.
to set the S‐tag of the EVC.
, and press E
ethernet 1/A/1
, and press E
<shelf/slot/group>
enable the EVC.
Enable prompt.
Section 6, EoTDM Provisioning - Create an EVC Cross Connect
Table 6-4. Available S-tag Range
NTER
to connect the active SM Net 1 interface to the EVC.
to connect the EFM bonding group to the EVC.
NTER
NTER
to get to the Glo‐
NTER
.
NTER
to
NTER
to return to the
NTER
6-15