Provision the LACP Switchover Mode
A difference in the way that Cisco and Juniper switches handle LACP messaging requires a
provisioning option, called lacp grammar standby‐aggregation. To set this option, complete
the following:
1. From the Enable prompt, type configure terminal , and press E
2. From the Global Configuration prompt, type interface gigabit-ethernet 1/A/1 ,
NOTE
If slot B is the active SM, use 1/B/1 for the <shelf/slot/port> designator.
3. Depending on the switch, perform one of the following:
NOTE
The no version of the lacp grammar command is the default value.
4. Type end , and press E
65K510DEP08-1A
bal Configuration prompt.
and press E
NTER
to access the Gigabit‐Ethernet prompt for the active SM, network port 1.
• If the Total Access 5000 is connected to a Cisco switch, type no lacp grammar
standby-aggregation
• If the Total Access 5000 is connected to a Juniper switch, type lacp grammar
standby-aggregation
NTER
Section 3, Common Provisioning - Provision the GigE SM
, and press E
NTER
.
, and press E
NTER
.
to return to the Enable prompt.
NTER
to access the Glo‐
3-11