NOTE
If the start of the test session is never reached, only the control timeout is
used.
5. From the TWAMP Responder Configuration prompt, type control timeout <1-
6. From the TWAMP Responder Configuration prompt, enable the TWAMP responder, by
7. Type exit and press E
Current TWAMP Status
To view the current TWAMP status, complete the following:
From the Enable prompt, type show probe responder twamp to see the current TWAMP
status:
NetVanta800/8000#show probe responder twamp
TWAMP Reflector status
Table D‐2 contains a description of the statistics listed in the example above:
65K510DEP08-1A
The default value is 900.
, and press E
65535>
NTER
The control timeout is similar to the test session timeout, but the control timeout applies
to the control session phase of TWAMP. The control sesion phase uses the TCP protocol.
The default value is 900.
typing no shutdown , then press E
State: Enabled
Control Port: 862
Timeouts
Control: 900 seconds
Test:
900 seconds
Test Packets
Received: 745
Sent:
745
Sessions
Active:
3 of 6
Opened:
15
Closed:
12
Rejected: 13
Appendix D, TWAMP Provisioning - Current TWAMP Status
to set the control session responder timeout in seconds.
.
NTER
NTER
to exit to the Global Configuration prompt.
D-5