Provisioning Summary
To provision for BSM, complete the following procedure:
1. Provision the Line Module.
2. Create a Point‐to‐Point Protocol (PPP) group consisting of T1 interfaces, and assign the IP
3. Create an EVC to connect the PPP group to a VLAN going out the Gigabit Ethernet port,
4. Create an EVC map to define the DSCP‐to‐priority bit mapping and to create the EVC‐to‐
65K510DEP08-1A
For more information, refer to "Provision the Line Module" on page 5‐4.
address of the subtended device, the IP address of the Edge router, and any DNS
addresses to the created PPP group.
The IP address and the DNS addresses are pushed down to the customer router
subtended off the Total Access 5000.
For more information, refer to "Create a Point‐To‐Point Protocol Group" on page 5‐7.
to the Edge router.
For more information, refer to "Create an EVC Cross Connect" on page 5‐12.
PPP group mapping.
For more information, refer to "Create an EVC Map on the Total Access 5000" on page 5‐
15.
Section 5, BSM Provisioning - Provisioning Summary
5-3