9. Type exit , and press E
10. Type exit , and press E
11. A MIP can be created on a specific VID and specific MD level by entering the Default
12. From the Global Configuration prompt, enter the Ethernet CFM Default MD by typing
13. From the Default‐MD Component prompt, type component 1 vlan <2-4094> , and
14. From the Default‐MD Component prompt, type level <0-7> , and press E
15. From the Default‐MD Component prompt, type mip-allowed any , and press E
16. Type exit , and press ENTER to return to the Global Configuration prompt.
65K510DEP08-1A
Appendix C, Ethernet OAM Provisioning - Ethernet OAM on the NetVanta 800/8000 Series NCTE
Single‐tag CFM service for s‐tag 100:
• Component 1 VLAN 100 Down MEP on the MEN‐port
• Component 1 VLAN 100 Up MEP on the UNI defined by an EVC‐map connected to
the EVC with s‐tag 100
Single‐tag CFM service for c‐tag 20 towards customer:
• Component 2 VLAN 20 Down MEP on the UNI‐port for customer CFM service
operability.
Double‐tag CFM service for s‐tag 100, c‐tag 20 destined for a Provider network:
• Component 2 VLAN 20 Up MEP on the UNI‐port defined by an EVC‐map connected
to the EVC with s‐tag 100
NTER
NTER
MD. The MIP will be created on all MEN‐ports with that VID so long that a Down MEP
on the same VID doesn't exist at a equal or higher level.
ethernet cfm default-domain
press E
NTER
to configure the MIP creation settings for the specified Provider VLAN.
A prerequisite for editing a Default‐MD Component is that the VLAN must already be
defined by a EVC using the same s‐tag and in the Running state. If no such EVC exists,
then the MIP rules cannot be accessed for that Default‐MD Component VID.
creation will be attempted at the specified MD level for this Provider VID.
allow MIPs to be created on this Provider VID.
to return to the MD prompt.
to return to the Global Configuration prompt.
, and press E
NTER
.
NTER
. The MIP
NTER
to
C-7