Rpr Provisioning; Scope Of This Appendix; In This Appendix; Basic Rpr Rules - ADTRAN Total Access 5000 Deployment Manual

Appendix L

Scope of this Appendix

This appendix details the steps to provision the Total Access 5000 network in a Resilient
Packet Ring (RPR) configuration.

In this Appendix

This appendix contains the following topics:
Topic
Basic RPR Rules
Ethernet Ring Diagrams
Central Office Terminal (COT) Node Provisioning
Remote Terminal (RT) Provisioning

Basic RPR Rules

When provisioning RPR, the following rules must apply:
• RPR Rings can originate from the COT Node or a RT Node. If the Ring originates at an RT
• Ring Speed is 2.5G with Add/Drop of 1G per span
• The same VLAN cannot be configured on Multiple nodes within a Ring. If done, the
• Ensure the S‐tag TPID in the Switch Module is set to 0x8100
• RPR is supported with a pair of cards in adjacent slots (odd/even pairs). Each card
65K510DEP08-1A
node, then that RPR card must be configured as a Hub
Active RPR Line Module raises a VLAN Mis Config alarm on the COT Node
provides one of the Node's links on the ring

RPR Provisioning

Table L-1. Appendix L Topics

See Page
L‐1
L‐2
L‐3
L‐8
L-1