Configure Default Network Interface; Configure Evcs - ADTRAN Total Access 5000 Deployment Manual

Total Access 5000 Business Services Deployment Guide
3. From the Gigabit Ethernet Interface Configuration prompt, type lacp mode active or
4. Repeat steps 2 to 3 to enable LACP for all active gigabit‐ethernet interfaces in the link
5. From the Gigabit Ethernet Interface Configuration prompt, type end , and press E

Configure Default Network Interface

To configure the default network interface, complete the following procedure:
1. From the Enable prompt, type configure terminal , and press E
2. From the Global Configuration prompt, type ethernet default interface lag-
3. From the Global Configuration prompt, type end and press E

Configure EVCs

Once a link aggregation group is created, it can be included in the Total Access 5000 cross
connects. To create an EVC and connect it to a link aggregation group, complete the following
procedure:
1. From the Enable prompt, type configure terminal , and press E
2. From the Global Configuration prompt, type evc WORD , and press E
3. From the EVC Interface Configuration prompt, type s-tag <1-4094> , and press E
4. From the EVC Interface Configuration prompt, type connect men-port lag-group
NOTE
This command entry applies to the active GigE SM, independent of which
GigE SM is actually specified, in an Active/Standby configuration.
5. From the EVC Interface Configuration prompt, type connect men-port efm-group
NOTE
The EFM bonding group shelf/slot/group designation can be used in lieu of
the group name.
A-4
, and press E
lacp mode passive
mode.
aggregation group.
return to the Enable prompt.
bal Configuration prompt.
, and press E
group 1/A/1
link aggregation group.
prompt.
bal Configuration prompt.
with name evc_name.
to set the S‐tag of the EVC.
, and press E
<1/slot/port>
EVC.
, and press E
<shelf/slot/group>
to configure the interface for the desired LACP
NTER
NTER to set the default network interface to the newly created
to connect the desired link aggregation group to the
NTER
NTER to connect the EFM bonding group to the EVC.
NTER
NTER to access the Glo‐
NTER to return to the Enable
NTER to get to the Glo‐
NTER to create an EVC
NTER
65K510DEP08-1A
to