Modify a Bonding Group Directly
To modify a bonding group directly, complete the following procedure:
1. From the Enable prompt, type application , and press E
2. From the Application Configuration prompt, type ez-efm 1 and press E
3. If required, modify the active‐links‐minimum or modify the upstream and downstream
4. From the Enable prompt, type configure terminal , and press E
5. From the Global Configuration prompt, type interface efm-group <group_name> ,
6. From the EFM Group Interface Configuration prompt, type one of the following
7. From the EFM Group Interface Configuration prompt, type exit and press E
65K510DEP08-1A
Configuration prompt.
EZ Ethernet application.
rates from the EFM Configuration prompt, type modify <group_name> link <slot/
port> upstream <0-250000> downstream <0-250000> active-links-minimum
, and press E
<1-n>
NTER
Global Configuration prompt.
and press E
NTER
to access the EFM Bonding Group Configuration prompt.
commands to add or remove a link to the EFM bonding group.
• From the EFM Group Interface Configuration prompt, type link <slot/port> ,
and press E
NTER
to add a link to the EFM bonding group
• From the EFM Group Interface Configuration prompt, type no link <slot/port> ,
and press E
NTER
to remove a link from the EFM bonding group
return to the Application Configuration prompt.
Section 4, EoCu Provisioning - Create an EFM Bonding Group
to modify an existing EFM Bonding Group.
NTER
to access the Application
NTER
to start the
to access the
NTER
NTER
to
4-11