5. From the EFM Configuration prompt, type exit , and press E
Modify a Bonding Group Directly
To modify a bonding group directly, complete the following:
1. From the Enable prompt, type configure terminal , and press E
2. From the Global Configuration prompt,type interface efm-group <group_name> ,
3. From the EFM Group Interface Configuration prompt, type one of the following
4. From the EFM Group Interface Configuration prompt, type one of the following
5. From the EFM Group Interface Configuration prompt, type exit and press E
65K510DEP08-1A
Refer to Table
6‐3 on page 6‐7 for the list of variables for the EFM bonding group.
Application Configuration prompt.
bal Configuration prompt.
and press E
to access the EFM Bonding Group Configuration prompt.
NTER
commands to add a link to the EFM Bonding Group:
• To provision the DS3 EFM 4‐Port, type link <slot/port> , and press E
• To provision the DS3 EFM 3‐Port, type link <slot/port:channel> , and press
E
.
NTER
commands to remove a link to the EFM Bonding Group:
• To provision the DS3 EFM 4‐Port, type no link <slot/port> , and press E
• To provision the DS3 EFM 3‐Port, type no link <slot/port:channel> , and press
E
.
NTER
return to the Application Configuration prompt.
Section 6, EoTDM Provisioning - Create an EFM Bonding Group
NTER
to return to the
NTER
to access the Glo‐
NTER
.
NTER
NTER
to
6-11
.