Total Access 5000 Business Services Deployment Guide
NOTE
Valid <command_type> values are csu, fdl, and feac.
NOTE
Valid <command_type> values are csu, fdl, and feac.
4. From the T1 Interface Configuration prompt, type end , and press E
Test Administrative Functions
The Total Access 5000 CLI Application prompt, controls both the local loopback and BERT
functions. While in the Application prompt, the following commands can be issued:
• View the current test status of the DS3 interface by typing show test interface t1
• Clear the test statistics of the DS3 interface by typing test interface t1
• Stop any test in progress (loopback or BERT) by typing no test interface t1
Local Line Loopback Configuration
To configure local DS3 loopbacks, complete the following steps:
1. From the Enable prompt, type application , and press E
2. From the Application prompt, type test interface t1 <shelf/slot/
NOTE
• The loopback timeout is optional and can be left off the loopback command
NOTE
• The DS3 line loopback can be stopped by typing no test interface t1
<shelf/slot/port:channel>
BERT Test Configuration
The Channelized DS3 Multi‐Service 3‐Port performs BERT generation and testing at the DS3
interfaces. To configure the DS3 BERT, complete the following steps:
1. From the Enable prompt, type application , and press E
G-6
• Type no remote-loopback , and press E
loopback commands.
Enable prompt.
<shelf/slot/port:channel>
<shelf/slot/port:channel> clear
<shelf/slot/port:channel>
prompt.
port:channel> local loopback line timeout <0-9999>
a DS1 line loopback.
prompt.
to provision the port to ignore remote
NTER
, and press E
NTER
, and press E
NTER
, and press E
NTER
, and press E
NTER
NTER
to return to the
NTER
to access the Application
, and press E
NTER
to start
NTER
to access the Application
65K510DEP08-1A