Total Access 5000 Business Services Deployment Guide
Provision the Line Module
This section details provisioning the Line Module service state.
Provision the Line Module Administration Status
The DS3 EFM 4‐Port or DS3 EFM 3‐Port card service state must be set to IS or Out of Service,
Maintenance.
NOTE
If the card service state is set to Out of Service, Maintenance, normal
operation occurs but alarms are not reported.
For traffic to pass, the DS3 EFM 4‐Port or DS3 EFM 3‐Port module must be enabled.
Table 6‐2 displays the three administration states and shows the equivalent Service State from
prior releases.
Command
no shutdown
shutdown maintenance
shutdown
To set the module administration and port administration states, complete the following:
1. From the Enable prompt, type configure terminal , and press E
NOTE
If connected to the shelf where the module resides, the shelf number is
typically 1.
2. From the Global Configuration prompt, provision the module administration state by
3. From the Global Configuration prompt, type one of the following commands:
6-4
Table 6-2. DS3 EFM 4-Port and DS3 EFM 3-Port Administration States
bal Configuration prompt.
performing one of the following commands:
• Type no slot shutdown <shelf/slot> , and press E
• Type slot shutdown maintenance <shelf/slot> , and press E
slot Out of Service Maintenance
• Type slot shutdown <shelf/slot> , and press E
Service, Unassigned
Previous
Description
In Service
In the
and alarms are generated.
Out of Service,
In the
Maintenance
fic passes but no alarms are generated.
Out of Service,
In the
Unassigned
and no alarms are generated.
no shutdown
state, traffic passes
shutdown maintenance
state, traf‐
shutdown
state, no traffic passes
to access the Glo‐
NTER
NTER
to take the slot In Service
NTER
to take the
to take the slot Out of
NTER
65K510DEP08-1A