Ethernet Oam For Business Service Migration; Figure C-2. Ethernet Oam (Bsm - ADTRAN Total Access 5000 Deployment Manual

• Primary Vid ‐ None, 1‐4094
• Level ‐ 0‐7
The NetVanta 8000 supports creation of Maintenance Association Intermediate Points (MIP)
with the following configurable attributes:
• Interface ‐ Any interface transporting Ethernet services. The interface must also be
• Component ‐ Provider only
• Primary VID ‐ 2‐4094
• Level ‐ 0‐7

Ethernet OAM for Business Service Migration

Figure C‐2 shows a typical Total Access 5000 BSM deployment. Use Ethernet OAM to verify
Ethernet connectivity between the PPP group/Ethernet interface in the Total Access 5000 #1
and the PPP group/Ethernet interface in the Total Access 5000 #2.
The Total Access 5000 supports the following features for Ethernet OAM:
• Network‐facing Down MEPs and MIPs only on tag‐switched EVCs at the GigE SM
• Network‐facing Up MEPs at the PPP group interface (BSM only)
65K510DEP08-1A
Appendix C, Ethernet OAM Provisioning - Ethernet Operation, Administration, and Management
–Customer Component (C‐Component) ‐ A flow that is switched by c‐tag, defined
by an EVC‐map, and classified onto an EVC by the EVC‐map's matching criteria.
operating as a MEN‐port
interface
Customer
Site
PPP Group
CPE Router
Demarcation
Total Access 5000 #2
Total Access 5000 #1
Network
End to End OAM or multi-hop OAM

Figure C-2. Ethernet OAM (BSM)

Demarcation
Customer
Site
PPP Group
802.1ag
CPE Router
C-3